DARTA DIGITAL AUDIO · TWO-FOOTSWITCH FUZZ PLUGIN
A heavy fuzz, modeled part by part: two transistors and an LED, a filter that tilts the tone and scoops the mids wherever you choose, and a second footswitch, MORE HEAVY, with one more gain stage. Plus a GATE that listens to the clean guitar, and the guitar simulated in front of the pedal.
Charged in Brazilian Reais (BRL), converted from US$ 19 at the day’s exchange rate. PayPal or your card converts it back and shows the exact amount in your currency before you confirm. Download link and license key by e-mail right after payment. Windows and Mac.

Tectonic weight.
Some fuzzes were born for slow riffs and walls of amps. The Tecton circuit puts two transistors in cascade, an LED that clips only one side of the wave and a T filter that tilts the tone and scoops the mids; a second footswitch adds one more gain stage for when the riff needs more. Tecton models that circuit with the schematic's values, simulates the guitar in front (the fuzz input interacts with the pickup, like a real pedal) and adds a gate that listens to the clean guitar.
Fuzz with an LED
Two transistors in cascade and an orange LED that clips only the positive side of the wave: an asymmetric saturation, thick and full of harmonics.
A filter that carves the mids
SLOPE tilts the tone, NOTCH sets how deep the scoop is and the SHIFT switch picks where it falls, from 0.5 to 1.2 kHz.
A second footswitch for more weight
MORE HEAVY switches in one more gain stage after the filter: up to +13 dB and more low end, on its own footswitch.
The controls
Seven knobs, a three-way switch and two footswitches. All of them can be automated in your DAW.

INPUT
How much guitar goes into the fuzz: a resistor in series with the input, like in the original circuit. Below 10, less gain and a darker sound; at 10, all of it.
SLOPE
Tilts the tone after the fuzz. Low, more lows and fewer highs; high, brighter, with the mid scoop moving down.
LEVEL
The pedal’s volume. At 3 it matches the level of the guitar with the pedal off; above that, up to +24 dB.
GUITAR
Your guitar’s volume knob, recreated. The guitar (a humbucker) is simulated in front of the pedal because the fuzz input loads the pickup, like a real pedal: rolling GUITAR back cleans up the fuzz instead of just turning it down.
SHIFT
Picks where the mid scoop falls: LOW (0.5 to 0.7 kHz), MID (0.6 to 0.8 kHz) or HIGH (0.85 to 1.2 kHz), with SLOPE between 5 and 10.
NOTCH
How deep the mid scoop is. At 0, the deepest (like the original, turning left cuts more); at 10, almost flat.
GATE
Closes in the pauses. It listens to the clean guitar, before the pedal, so it doesn’t eat the end of your notes. At 0 it is off.
MORE HEAVY
The gain of the second footswitch: from +0.3 dB at 0 to +13 dB at 10 over the sound without it. It only works with the MORE HEAVY footswitch on.
FOOTSWITCHES
ON turns the pedal on with no click (red LED). MORE HEAVY switches in the extra gain stage (amber LED).
SHIFT: where the scoop falls
The middle switch changes the filter capacitor and moves the mid scoop to three places. Ranges measured with SLOPE between 5 and 10.
LOW
The lowest scoop: it takes out the low mids and leaves the top open.
Great forHeavy riffs and low tunings.MID
The middle point and the default: this fuzz's classic scoop, with lows and highs around it.
Great forFuzz and stoner rhythms.HIGH
The scoop moves up and the low mids come back: a thicker sound with more presence.
Great forLeads and busy mixes.MORE HEAVY: the second footswitch
One more gain stage, after the filter, on its own footswitch.
More gain
The MORE HEAVY knob sets how much: from +0.3 dB at 0 to +13 dB at 10, measured with a guitar. Play the riff on the fuzz and stomp on MORE HEAVY when the song asks for more.
More low end
With MORE HEAVY on, the filter output sees less load and the lows rise 2 to 6 dB at 100 Hz, like on the original pedal. That's the extra weight in the name.
16 presets to start with
In four categories. And you can save your own with SAVE, compare two settings with A and B, and undo with UNDO.
Fuzz · 4
Heavy · 4
Lead · 4
Special · 4
Tips to get the most out of it
Ideas to get started.
Start at 3
With LEVEL at 3, switching the pedal on and off doesn’t change the volume, so you judge the sound, not the loudness.
In front of a clean sound
It was made for the input of a clean amplifier. In an amp sim, pick a clean channel; straight into a cab IR works too.
Your guitar's volume
Roll GUITAR back to 6 and the fuzz cleans up, like a real pedal. Try the Guitar Cleanup preset.
Mids to cut through the band
NOTCH at 8 or more and SHIFT on HIGH: the mids come back and the fuzz doesn’t hide behind the bass and drums.
Doom
MORE HEAVY on with the knob at 8, SLOPE at 2, SHIFT on LOW and GATE at 4. Try the Doom preset.
Less gain, same fuzz
Low INPUT: less guitar goes in and the fuzz gets more open and darker. Try the Low Input Grit preset.
Under the hood
Checked against circuit simulation
The whole circuit was compared with SPICE, the circuit simulator engineers use: the operating point matches to five decimal places, the frequency response stays within 0.06 dB up to 10 kHz and, with a strong signal, every octave stays within 0.1 dB of the full transistor models.
Real transistors and LED
The three transistors and the LED follow the parts' curves, solved at every sample.
The guitar in front
Pickup, guitar volume and cable are simulated before the pedal: the fuzz input loads the pickup like a real pedal.
8x oversampling
The distortion runs at 8x your DAW's rate, so the highs stay clean.
Try before you buy
Download the trial with everything unlocked: every control, all 16 presets and the standalone app with amp and cabinet. The only difference is that the sound drops out for 3 seconds every 45 seconds and presets can’t be saved. Like it? Buy a license and paste the key into the plugin, no reinstall needed.
Windows 10 and 11 (VST3 and standalone) and macOS 10.15 or newer (AU, VST3 and standalone).
Specifications
System
Windows 10 or 11, 64-bit. macOS 10.15 or newer (Intel and Apple Silicon).
Formats
Windows: VST3 and standalone application. Mac: AU, VST3 and standalone application.
License
One license key activates up to 2 computers. Once activated, it works offline.
Controls
Input, Slope, Level, Guitar, Shift (Low, Mid, High), Notch, Gate, More Heavy and the On and More Heavy footswitches.
Channels
Mono or stereo. A mono guitar comes out on both sides.
FAQ
Which gear is it based on?
On the Mountainking Electronics Megalith: a two-footswitch fuzz built for heavy riffs. Mountainking Electronics and Megalith are trademarks of their respective owners; Darta is not affiliated with them and the names are used here only to describe the style of sound.
Why is there a GUITAR knob?
Because a fuzz like this one loads the guitar: the input interacts with the pickup, and the guitar’s volume knob changes the sound, not just the level. An audio interface doesn’t do that, so Tecton simulates the pickup, the volume knob and the cable in front of the pedal. Keep your guitar’s volume all the way up and use GUITAR.
Does it have a clean sound?
No: it’s a fuzz. For less saturation, lower INPUT or GUITAR.
Is there latency?
Only 5 samples (about 0.1 ms at 48 kHz), because of the oversampling: imperceptible. The bypassed sound is delayed by the same amount, so switching on and off sounds seamless.
Is there a Mac version?
Yes. TECTON runs natively on Apple Silicon and Intel Macs, macOS 10.15 or newer, as AU, VST3 and standalone.
Do I need internet to use it?
Only to activate it. After that, TECTON works offline.
Can I use it on more than one computer?
Yes, each license key activates up to 2 computers. To move it, deactivate it on the old computer from inside the plugin.
How do I get the plugin?
Right after payment, you get the download link and your license key by e-mail. Both are also in My account.
What currency will I be charged in?
Darta is based in Brazil, so checkout is in Brazilian Reais (BRL): the US$ 19 price is converted at the day’s exchange rate. PayPal or your card issuer converts it back automatically and shows the exact amount in your currency before you confirm. Depending on their conversion rate, the final amount may differ slightly from US$ 19.
Can I play without a DAW?
Yes. The standalone app comes with a clean amp (VOLUME, BASS, MIDDLE and TREBLE) and a 1×12 cabinet, or your own IR. Just plug your guitar into your audio interface and play. In your DAW, the plugin is just the pedal, so you can use any amp and cabinet you like.
Is there a trial version?
Yes. Leave your e-mail under Try before you buy and download it right away. Everything works; the sound just drops out for 3 seconds every 45 seconds and presets can’t be saved. Once you buy, just paste the key into the plugin.
Tectonic weight.
Charged in Brazilian Reais (BRL), converted from US$ 19 at the day’s exchange rate. PayPal or your card converts it back and shows the exact amount in your currency before you confirm. Download link and license key by e-mail right after payment.

